Venta LW15 COMFORT Plus Mode D'emploi page 27

CLEANING THE UPPER HOUSING OF THE DEVICE
01 06
Attention! Ensure that the device is switched off during any measu-
res and the switching power supply is disconnected from the outlet!
01 Detach upper housing from lower housing. Press locking buttons so that
the ends stand up.
Fold side parts out of the way.
02
Fold ribbed wings out of the way.
03
Pull the plug of the switching power supply out of the drive unit
04
drive unit upwards and out
power supply from the holding bracket
of the upper housing downward and out
∙ Do not disassemble the drive unit and switching power
supply, do not submerge into the water and do not bring in
contact with liquid!
∙ Only clean the drive unit with fan blades and gear with a dry
cloth!
∙ The disassembled upper housing can be cleaned under
running water!
∙ The disassembled upper housing must be absolute dry befo-
re assembly!
05 Place drive unit in upper housing and ensure that it is laterally correct
Pull plug of switching power supply from bottom through opening of the
upper housing upwards
cable in holding bracket
The outer ends of the locking buttons must be standing up. Fold ribbed
06
wings and
1
housing properly again by pushing on the outer ends of locking buttons
and .
6
. Disconnect the cable from the switching
2
and plug into drive unit up to the limit
2
.
4
upwards, and finally the side parts
2
and pull out through the opening
3
.
4
and
3
Venta Comfort
. Pull
1
.
1
. Fasten
3
. Close upper
4
5
EN 21
Plus