CLEANING & MAINTENANCE
Attention! Ensure that the device is switched off during any measu-
res and the switching power supply is disconnected from the outlet!
Display
WATER
7
8
SERVICE
Any remaining liquid in the water tray and on the disk stack (white, green-yellow
or brown deposits or discolorations) do NOT impair the function of the device.
For the six-monthly cleaning, we recommend the Venta Cleaner. Please note the
instruction manual included with the Venta Cleaner.
20
EN
Measures
Remove upper housing. Fill lower housing with tap water up
to the WATERLINE marking. Place upper housing on lower
housing and put device in operation again.
i
As soon as there is not enough water in the lower housing, the device is
switched off automatically and the WATER display appears. In the
HUMIDITY display 1, two lines will flash and the humidity in the room is not shown.
To humidify and clean the room air continuously, we recommend
refilling the water in a timely manner.
Remove upper housing. Drain residual water from lower hous-
ing. Rinse lower housing and disk stack. Fill lower housing with
tap water up to the WATERLINE marking maximum and add
the Venta hygiene additive (for dosage see scale on rear of bot-
tle). Re-assemble the device. Touch SERVICE display 8 in the
display and hold it for 3 seconds until it goes off.
i
For flawlessly hygienic continuous operation, the SERVICE display
indicates a reminder every 14 days that this measure needs to be
carried out.
This measure can be carried out if required, even if the SERVICE
message is not shown. Afterwards, simply touch SERVICE display 8
and hold for 3 seconds. The next reminder will now be shown again in 14
days with the SERVICE message
7
8