Overview; Putting Into Operation - Venta LW60T Mode D'emploi

OVERVIEW

Display
1
2 On/off switch
Evaporator compartment
3
4 Water tank
Disc stack
5
6 Water basin

PUTTING INTO OPERATION

01 08
Attention! Make sure that the appliance is switched off and the
power plug is disconnected.
01 Unpack the appliance and set it up.
02 Open the evaporator compartment 3 and remove the water tank 4.
03 Open the water tank 4 and fill up to the MAX marker with water.
04 Close the water tank 4 securely.
05 Insert the water tank 4 into the water basin 6 and close the evaporator
compartment 3.
Inserting the fragrance: Open the fragrance compartment 7. Twist open the
06
fragrance cap and insert it into the fragrance holder 8. Insert up to three
fragrances into the fragrance holder 8. Close the fragrance compartment 7.
The display 1 can be adjusted to three positions.
07
The power cable can be adjusted to the desired length by winding it up in
08
the cable compartment 9.
Move the appliance with the transportation wheels 12 to the desired place.
Lift the appliance slightly on the right sight.
ATTENTION! The coupling of the mains cable must be plugged firmly into the
device! Please remove the protective foil for battery and remote control.
Connect the power plug and switch on the
appliance at the on/off switch 2 or with the
remote control 11.
ATTENTION! It may take about a minute for the
device to start and for the "Fill Tank" indicator in red or yellow to be extinguished.
A gurgling sound may be heard, but this does not represent a quality defect.
13 GB
Fragrance compartment
7
8 Fragrance holder
Cable compartment
9
10 Hygiene Disc (pre-assembled)
11 Remote Control
12 Transportation wheels
ON/OFF
Set fan stage