Overview; Putting Into Operation - Venta LW60T Mode D'emploi

OVERVIEW

1 Display
2 On/off switch
Evaporator compartment
3
Water tank
4
5 Disk stack
Water basin
6

PUTTING INTO OPERATION

01 08
Attention! Make sure that the appliance is switched off and the
power plug is disconnected.
01 Unpack the appliance and set it up. Open the fragrance compartment 7.
Insert up to three fragrances into the fragrance holder 8.
Close the fragrance compartment 7.
02
03 Open the evaporator compartment 3 and remove the water tank 4.
04 Open the water tank 4 and fill up to the MAX marker with water.
Close the water tank 4 securely.
05
06 Insert the water tank 4 into the water basin 6 and close the evaporator
compartment 3.
The display 1 can be adjusted to three positions.
07
08 The power cable can be adjusted to the desired length by winding it up in
the cable compartment 9.
Attention! The coupling of the mains cable must be plugged firmly into the device!
Please remove the protective foil for battery and
remote control of the remote control.
Connect the power plug and switch on the
appliance at the on/off switch 2 or with the
remote control 11.
ATTENTION! It may take about a minute for the device to start and for the "Fill
Tank" indicator in red or yellow to be extinguished. A gurgling sound may be
heard, but this does not represent a quality defect.
13
GB
All manuals and user guides at all-guides.com
7 Fragrance compartment
8 Fragrance holder
Cable compartment
9
10 hygiene Disc (pre-assembled)
11 Remote Control
ON/OFF
Set fan stage