Overview; Putting Into Operation - Venta LP60 WiFi Mode D'emploi

OVERVIEW

1 Display
On/off switch
2
3 filter compartment
Pre-filter
4
5 Filter

PUTTING INTO OPERATION

01 05
Attention! Make sure that the appliance is switched off and the
power plug is disconnected.
01 Unpack the appliance and set it up. Open the filter compartment
3+6, remove the pre-filter 4+7, remove the VENTAcel filter 5+8 and open them.
Re-insert the VENTAcel filter 5+8 and pre-filter 4+7.
02
Close the filter compartment 3+6.
03
The display 1 can be adjusted to three positions.
04
The power cable can be adjusted to the desired length by winding it up in
05
the cable compartment 9
Attention! The coupling of the mains cable must be plugged firmly into the
device!
Please remove the protective foil for
battery and remote control.
Connect the power plug and switch on the ap-
pliance at the on/off switch 2 or with the remote
control 10.
15 GB
6 filter compartment
Pre-filter
7
8 Filter
Cable compartment
9
10 Remote control
ON/OFF
Set fan stage