Overview; Putting Into Operation - Venta LW60T WiFi Mode D'emploi

OVERVIEW

Display
1
2 On/off switch
Evaporator compartment
3
4 Water tank
Disc stack
5

PUTTING INTO OPERATION

01 07
Attention! Make sure that the appliance is switched off and the
power plug is disconnected.
01 Unpack the appliance and set it up. Move the appliance with the trans-
portation wheels 10 to the desired place. Lift the appliance slightly on the
right sight.
02 Open the evaporator compartment 3 and remove the water tank 4.
03 Open the water tank 4 and fill up to the MAX marker with water.
04 Close the water tank 4 securely.
05 Insert the water tank 4 into the water basin 6 and close the evaporator
compartment 3.
The display 1 can be adjusted to three positions.
06
The power cable can be adjusted to the desired length by winding it up in
07
the cable compartment 7.
ATTENTION! The coupling of the mains cable must be plugged firmly into the
device! Please remove the protective foil for battery and remote control.
Connect the power plug and switch on the
appliance at the on/off switch 2 or with the
remote control 9.
ATTENTION! It may take about a minute for the
device to start and for the "Fill Tank" indicator in red or yellow to be extinguished.
A gurgling sound may be heard, but this does not represent a quality defect.
15 EN
Water basin
6
7 Cable compartment
Hygiene Disc (pre-assembled)
8
9 Remote Control
10 Transportation wheels
ON/OFF
Set fan stage