Overview; Putting Into Operation - Venta AP902 Mode D'emploi

OVERVIEW

1 Display
2 On/off switch
3 Filter compartment
4 Coarse dust filter
5 HEPA filter
6 Filter compartment
7 Coarse dust filter
8 HEPA filter
9 Cable compartment
10 Remote control

PUTTING INTO OPERATION

Attention! Ensure that the device is switched off during all actions and the
!
switching power supply is disconnected from the outlet!
1 Unpack and set up the appliance. Remove battery protection and protective
foil from remote control 10.
2 Open filter compartments 3+6 and remove coarse dust filters 4+7.
3 Remove HEPA filters 5+8 and open them.
4 Re-insert opened HEPA filters 5+8 and coarse dust filters 4+7 and close filter
compartments 3+6.
5 Adjust display 1 to the position you want (3 positions possible).
6 Adjust cable connector to the length you want by winding/unwinding in cable
compartment 9. Note: Make sure the cable connector is firmly fitted into the
appliance!
Connect power plug to mains and switch appliance on using on/off switch 2 or
remote control 10.
10 EN
1
2
3
4
5
AP902
6
7
8
9
10