Before Setting The Controls; Setting The Controls - KitchenAid KDRP407H Guide D'utilisation Et D'entretien

U
sing the Self-Cleaning Cycle
TIPS:
• Keep the kitchen well ventilated during
the Self-Cleaning cycle to help get rid of
heat, odors, and smoke.
• Clean the oven before it gets heavily
soiled. Cleaning a very soiled oven takes
longer and results in more smoke than
usual.
• Do not block the vent during the
Self-Cleaning cycle. Air must move freely
for best cleaning results.
• Do not leave any foil in the oven during
the Self-Cleaning cycle. Foil could burn or
melt and damage the oven surface.
• The oven light will not work during the
Self-Cleaning cycle.
• Do not use your cooktop during the Self-
Cleaning cycle.
Before setting the
controls
• Make sure clock is set to
correct time of day. The clock
cannot be set during the
Self-Cleaning cycle.
• Make sure the oven door is
completely closed.

Setting the controls

To start cleaning immediately:
1. Turn SELECTOR to CLEAN.
2. Rotate SET to select "On".
3. Press ENTER to start a preset,
non-adjustable 3
28
1 ⁄ hour cycle.
2
To delay start cleaning cycle:
1. Follow steps 1-3 above, before
moving on.
2. Press ENTER twice.
The time the cycle will end is displayed
and the STOP TIME LED will blink.
3. Rotate SET to desired STOP
TIME.
4. Press ENTER to accept.
The DURATION and STOP TIME arrow
will illuminate.
NOTE: If you set a delayed start for the
clean cycle, the oven door will still lock.
You have to press CANCEL to cancel
your selection.
To stop the Self-Cleaning cycle at
any time:
Turn SELECTOR to RESET .
OR
Press CANCEL.
To view the time remaining:
Press ENTER.
The display will return to "cln" after
5 seconds.