Nice DPRO500 Instructions Et Avertissements Pour L'installation Et L'utilisation page 6

• "Electromagnetic compatibility" Directive:
Special warnings regarding the fitness of use of this product in relation to the "Electromagnetic compatibility" Directive.
This product has been subjected to electromagnetic compatibility tests in the most critical situations of use and in the configurations specified
in this instruction manual and in combination with the items in the Nice S.p.A. product catalogue.
If the product is used in unspecified configurations or with other unspecified products, the electromagnetic compatibility may not be guar-
anteed; the use of the product is prohibited in such circumstances until the installer has verified compliance with the specified requirements
of the directive.
Installation criteria and special warnings in connection with essential requirements
• When installed correctly, this product meets the essential requirements laid down in Regulation No. 305/2011 according to the requirements
in harmonised standard EN 13241-1, as indicated in Table 1 and in the European directive on "Machinery" 2006/42/EC.
• Release of dangerous substances:
The product does not contain and/or release hazardous substances in accordance with the requirements of EN 13241-1, 4.2.9 and accord-
ing to the list of substances on the website of the European Community
Special warning to ensure the continued compliance with the requirement – It is essential that the other materials used in the installation,
such as electrical cables, comply with this requirement.
• Safe opening for horizontally moving doors: the product does not cause uncontrolled movements.
Special warnings to ensure continued compliance of the requirements:
- Install the product carefully following all the instructions described in Chapter "2 - Installation" and Chapter "4 - Testing and commissioning".
- Ensure that a maintenance schedule is organised which scrupulously complies with all the provisions in the Chapter "Maintenance
Schedule".
• As regards the risks of crushing and impact, the sliding closures are protected by means of one of these three methods:
1 - For operation with "hold-to-run command" (man present): as specified in EN 12453, point 5.1.1.4. In this case the command button
must be placed in view of the automation and if it is accessible to the public, the command button must not be available to them, e.g.
use only with a key switch.
2 - For "Semi-automatic" operation: through the use of an active sensitive edge for limiting the forces as specified in EN 12453, paragraphs
5.1.1.5 and 5.1.3.
3 - For "automatic" operation: through the use of an active sensitive edge for limiting the forces as specified in EN 12453, paragraphs 5.1.1.5
and 5.1.3; in this case, at least one pair of photocells must be installed.
2 – English