Siemens SIMOVERT MASTERDRIVES Motion Control Instructions De Service page 182

Installation
Removing the
option card holder
Installing the
optional board
Slot C
Mounting the option
card holder
5-6
Remove the fixing screws of the option card holder from the pins and lift
the option card holder from the device.
♦ Push the optional board from behind into the opening on the front
cover ( ) until the position of the 64-pole system connector on the
main board corresponds with the position of the socket.
♦ Insert the optional board from the right onto the 64-pole system
connector on the main board (
state.
♦ Screw the optional board tight at the fastening points in the front
section of the optional board (
Fig. 5-6 Installing the optional board
Place the option card holder horizontally on the rear edge of all fitted
option cards and tighten the previously removed screws at the fixing
points.
). The view shows the installed
).
Slot B
Slot C
6SE7087-7JP50
Operating Instructions SIMOVERT MASTERDRIVES
08.2009
Siemens AG