Motor Fixing; Emergency Release - SCS Sentinel SCS1 STANDARD Manuel D'installation Et D'utilisation

EN
C

MOTOR FIXING

Prior to place the arm on the gate, take out the tub from the cyliner with a battery by
connecting white and yellow wires of motor and insert the tub from 3 cm in.
Assemble the rear bracket and fix it on the pillar.
Release the gate opener and place the pin into the fitting position no.1 and no. 2
Make sure verins arms are fixed in horizontal position especially in those positions.
1) Gate in "CLOSE" position
2) Gate in "OPEN" position
3) Gate at "45° angle" position
Prior to weld the bracket on the gate leaf(if necessary), cover the gate opener to
prevent damages from sparks.
D

EMERGENCY RELEASE

In case of power failure or to program your
automatic
gate, you can manually unlock the engines:
Stand in the inner side of the gate. Insert the
hex wrench for unlocking and then turn anti-
clockwise 180 degrees. You can now open
the gate by hand.
To lock again the engine, insert the hex
wrench for locking and then
turn clockwise 180 degrees.
EN ::: 30
20
20
no.1
no.1
A
A
B
B
no.2
A
no.2
A
B
B
180
o