System Learning Process - SCS Sentinel SCS1 STANDARD Manuel D'installation Et D'utilisation

EN

SYSTEM LEARNING PROCESS

DOUBLE GATE
The remote control memory storing operation must be over before starting
the final system learning process.
The LED2 light will remain ON until the system learning process is not over.
Let your gate totally opened. Press «SYS-learn» (until the LED2 light begins
to flash once every second, instead of twice every second as it normally would), then
press the upper-left key for a double gate and the upper-right key for a single gate.
The system learning process will be as follows, step by step:
1
4
After step 6, the system learning process is complete. You can use it with the remote
control:
1
3
3 double gate full opening
6
6
3
pedestrian opening (single gate)
3
EN ::: 42
2
5
2
3
6
3