Motor Fixing; Wire Connection - SCS Sentinel intensive4 Manuel D'installation Et D'utilisation

C

MOTOR FIXING

Assemble the rear bracket and fix it on the pillar.
Remove the wire cover and fix the rear bracket with the pin. Release the gate opener and place
the pin into the fitting position no.1 and no. 2
Make sure the gate openers are mounted in horizontal position especially in those positions.
1) Gate in "CLOSE" position
2) Gate in "OPEN" position
3) Gate at "45。angle" position
Prior to weld the bracket on the gate leaf(if necessary), cover the gate opener to prevent
damages from sparks.
D

WIRE CONNECTION:

3
no.1
TO CONNECT MASTIFF WITH CONTROL UNIT
Standard Motor
White Motor (+)
1
5
Yellow Motor (-)
2
4
Red -
3
3
Green -
4
2
Black -
5
1
B
no.2
A
With Hall Sensor
Motor (+)
Motor (-)
Hall Sensor (5V)
Hall Sensor (Signal)
Hall Sensor (GND)