EN
CONTROL BOX
INSTALLATION
BEFORE INSTALLATION
Decide the installation position of control box first, it is suggested to be installed near
the gate and should be protected from possible damage.
Be aware of the motor cable length before deciding the installation position.
PRE-INSTALLATION
1. Remove the cover by unscrewing the four screws on the cover. See Figure 1(1).
2. Use a screwdriver to puncture the holes beneath the bottom of the control box. See
Figure 1(2).
3. Secure it on the wall. See Figure 1(3).4. Connexion de câblage :
Figure 1(1)
Figure 1(2)
Figure 1(3)
EN ::: 31