Led Indication; Remote Control Learning Process - SCS Sentinel SCS1 STANDARD Manuel D'installation Et D'utilisation

RF1 Remote receive board
RF-Learn

LED INDICATION

SYS-Learn
LED1
LED2
LED3
LED4
OFF ON
SW1:Set
1. D/S set
2. Over_C1
3. Over_C2
4. Auto
5. Ph
NONE
1 2
LED 1 System Learning:
LED1 will be on when remote controls are activated.
LED 2 System learning:
LED 2 blinks twice per seconde during normal operation and once per seconde during
learning.
RX TX
LED 3 Photocells:
LED 3 will be on when photocells are not aligned.
LED 4 Start:
photocellules
LED 4 will be on if the switch of the transmitter, key selector, or the push button is
activated.
REMOTE CONTROLS LEARNING PROCESS
Press "RF-learn" button for 2 seconds, and the LED1 will be on; then press the transmitter
top left button, then top right button;
The LED1 will blink twice and stay on for 10 seconds then be off. And the remote
memorize has completed.
3 4 5 6
bouton
sélecteur
poussoir
à clé
FI
Fusible T20A
250V
7 8 9 10 11 12 13 14
feu
clignotant gâche
M1 M2
EN ::: 41
EN