Mettler Toledo IND231 Manuel D'installation page 24

2.4.5. Battery Installation
2.4.5.1. IND231
To install and connect the NiMH battery pack in the IND231 terminal:
1. Remove the plastic battery cover. Press on the end and slide off, as indicated in Figure 2-19
2-10 METTLER TOLEDO IND231/IND236 Installation Manual
FOR CONTINUED PROTECTION AGAINST SHOCK HAZARD CONNECT TO PROPERLY GROUNDED
OUTLET ONLY. DO NOT REMOVE THE GROUND PRONG.
Note: Before using the terminal, the battery should be charged for at least four hours.
RISK OF EXPLOSION IF BATTERY IS REPLACED WITH AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS.
Figure 2-19: Removing the Battery Cover
WARNING
CAUTION
Figure 2-20: Battery Enclosure
30094756 | 04 | 02/2021