Lotus BR-50-78G Instructions Pour L'installation Et L'utilisation page 14

Instruction for use
Attention! Before the first use of the appliance you must remove protection foil, wash the device and bath
with water containing washing liquid and then dry with the cleaning cloth. Into the bottom of the bath spread
a vegetable oil and begin burning procedure by 230°of Celsius. Before you start cooking, it is necessary
make this burning procedure. The optimum is about 3–5 days use appliance as frying pan, and then for
cooking. If pans washing was done by chemical substances, we recommend to use about 4-6 cycles as
frying pan before you start cooking in it again. The device cannot be used under any circumstances as
a fryer or its substitute
Ignition the main burner:
With lighter:
Slide the door on the left front panel and turn gas valve control knob to the ignition position (Fig.2, note 3
and Fig.6) and keep it pressed. Press the piezo lighter button couple of times. After burner ignition, keep
this button pressed for few second (about 10-20 sec.) until is the thermo fuse warmed up, then release
button. If the flame goes out, repeat the whole procedure again.
With electric burning:
Slide the door on the left front panel and turn gas valve control knob to the ignition position (Fig.2, note 3
and Fig.6) and keep it pressed. Flame will ignite automatically. After burner ignition, keep this button
pressed for few second (about 10-20 sec.) until is the thermo fuse warmed up, then release button. If the
flame goes out, repeat the whole procedure again.
Ignition of the main burner and thermo regulation
Turn gas valve control knob to the ignition position (Fig.6) and set button of thermostat to required
temperature. Main burner will ignite.
Switching off of the main burner
The main burner is possible switch off with turning thermostat button to "0"position, or turning the gas valve
control knob to ignition position. Main burner will go out, but pilot burner keeps working.
Switching off the whole device
Set the gas valve control knob to position off. At this moment all burners goes out.
Filling water to the bath
Open valve for water filling and when achieve required volume of the water, simply close it. Water fills up
only when the lid of the bath is open.
Draining of the bath
Tilt the bath to required position for her drain with help of the manipulation handle. Attention! Before you
start draining of the bath, attach under overflow suitable container. Keep maximum attention if you will be
manipulating with boiling content. After successful bath draining, return it back to operation position.
ATTENTION! When tilting the bath, main burner goes out, but automatically starting when returning
bath into operation position. Because of this, make sure before you start draining of the bath, that
main burner is switched off.
14