Wayscral EVERYWAY E-200 N Notice D'utilisation page 59

EN
Be careful not to exceed the minimum insertion mark. This insertion
mark should never be visible when the bicycle is in use.
Tighten the immersion screw ensuring the stem is in the correct
position.
To adjust the tilt of the handlebars, loosen the pivot bolts of the stem
indicated on the photo below with a 5 mm hex wrench, select the
position and tighten it.
.
To adjust the position of the handlebar on the stem, loosen the screws
on the stem cover (8), turn the handlebar as much as you want and
tighten these same screws. Take care that the handlebar is correctly
centred.
59