Error Codes - Magmaweld ID 500 TW DC PULSE Mode D'emploi

ID 500 TW DC PULSE

4.3 Error Codes

Error Code Error
Thermal
E01 Protection
(Primary)
Mains Voltage
E02
Mains Voltage
E03
Temperature Sensor
E05
Reading Error
High Output
E07
Voltage
High Primary
E09
Current
E12 VRD Error
Communication
E14
Thermal
E19 Protection
(Secondary)
www.magmaweld.com
• The uptime of your machine may have
been exceeded
• Fan may not be working
• The front of the air inlet-outlet ducts
may be blocked
• The machine working environment
may be too hot or stuffy
• Mains voltage may have decreased
Low
• Mains voltage may have increased
High
• There may be a hardware error
• There may be electrical problems in
the machine
• Low mains voltage may be present
• There may be electrical problems in
the machine
• There may be electrical problems in
Error the machine
• The uptime of your machine may have
been exceeded
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
• Allow the machine to cool down by
Cause
• If the problem continues, contact the
• Check visually whether the fan is
• If the problem continues, contact the
• Open the front of the air ducts
• If the problem continues, contact the
• Make sure that the working
• If the problem continues, contact the
• Check the mains connection cables
• Check the mains connection cables
• Contact the authorized service
• Contact the authorized service
• Contact the authorized service
• Contact the authorized service
• Contact the authorized service
• Allow the machine to cool down by
• If the problem continues, contact the
Maintenance and Service
Solution
waiting for a while. If the fault
disappears, try to use the machine at
lower amperage values
authorized service
working or not
authorized service
authorized service
environment of the machine is not
excessively hot or stuffy
authorized service
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
waiting for a while. If the fault
disappears, try to use the machine at
lower amperage values
authorized service
29
EN