Error Codes - Magmaweld ID 250E Mode D'emploi

ID 250E

4.3 Error Codes

Error Code Error
Thermal
E01 Protection
(Primary)
Mains Voltage
E02
Mains Voltage
E03
Current / Voltage
E04
Reading Error
Temperature Sensor
E05
Reading Error
Water Cooling
E06
Unit Error
E07
E08 System Error
E09
Torch Connection
E10
E11
System Error
E12
E13 Wire Feeder Error
www.magmaweld.com
• The duty cycle of your machine may
have been exceeded
• Fan may not be working
• The front of the air inlet-outlet ducts
may be blocked
• The machine working environment
may be too hot
• Mains voltage may have decreased
Low
• Mains voltage may have increased
High
• There may be a hardware error
• There may be a hardware error
• There may be an error in the water
cooling unit
• There may be a hardware error
• The torch or torch connections
Error may be faulty
• There may be a hardware error
• There may be an error in wire feeding
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
• Allow the machine to cool down by
Cause
• If the problem continues, contact the
• Check visually whether the fan is
• If the problem continues, contact the
• Open the front of the air ducts
• If the problem continues, contact the
• Make sure that the working
• If the problem continues, contact the
• Check the mains connection cables
• Check the mains connection cables
• Contact the authorized service
• Contact the authorized service
• Check water cooling unit connector
• Make sure there is water circulation
• If the problem continues, contact the
• Contact the authorized service
• Check torch and torch connections
• If the problem continues, contact the
• Contact the authorized service
• Check wire basket, reel / reel press
• If the problem continues, contact the
Maintenance and Service
Solution
waiting for a while. If the fault
disappears, try to use the machine at
lower amperage values
authorized service
working or not
authorized service
authorized service
environment of the machine is not
excessively hot or stuffy
authorized service
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
and torch inlets/outlets
authorized service
authorized service
and torch connections
authorized service
21
EN