Operation; User Interface; Tig Curve - Magmaweld ID 500 TW DC PULSE Mode D'emploi

ID 500 TW DC PULSE

OPERATION

3.1 User Interface

2 3

1- TIG Curve

Use the buttons to scroll through the parameters in the TIG curve. The led of the relevant parameter
will light up depending on which parameter is selected.
Darkening - deformation may occur in the welding area, if the shielding gas comes later
Pre Gas
than the arc start. In order to prevent this deformation, you can adjust pre gas timing before
arc. Furthermore, the life of the tungsten tip will be shortened. Initial gas function allows
adjustment between 0 -20 sec. By this setting, it is ensured that the gas reaches the welding
area before starting welding.
The welding arc will occur at the specified current value. The value is set in terms of %. Start
Start Current
current occurs below the specified% value of the main current and allows adjustment from
5A - %100.
www.magmaweld.com
1
4
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Operation
8 7
6 5
19
EN