Safety Equipment - Parker EOMAT ECO Guide D'utilisation

EOMAT ECO
The EOMAT ECO is a portable machine for the simple pre- and final assembly of EO Pro-
gressive ring and EO-2 fittings. With the EOMAT ECO even large tube dimensions can be
installed in areas where the use of an EOMAT assembly machine is not possible.
The EOMAT ECO consists of a hydraulically-driven tool and a hydraulic power unit. The
hydraulic assembly pressure is pre-set on a pressure switch and displayed.

4.2. Safety equipment

The machine is provided with ON and OFF buttons.
The assembly process is initiated by the ON button. It should be kept pressed down until
the assembly pressure has been achieved: only then will the cylinder move back to its
starting point.
If errors should occur during assembly, the cylinder can be taken back immediately to its
starting position via the OFF button.
Off button
On button
Page 16 EOMATECO/MANUAL