Receiving And Inspecting The Equipment; Storage; Unpacking; Overview Of The Equipment - Parker LCMS20/3 Guide D'utilisation

2.3 Receiving and Inspecting the Equipment

On receipt of the equipment carefully inspect the packaging for damage. If the packaging is damaged inform the delivery company immediately
and contact your local Parker Hannifin office.

2.3.1 Storage

If the equipment is to be stored prior to installation, do not remove it from the packaging. Ensure that it is stored in an upright position as
indicated by the arrows on the packaging.
Do not attempt to lift the generator by yourself. It is recommended that the generator be carried by a minimum of two persons or transported
on a pallet truck.
Note. The storage area should be secure and the environmental conditions should fall within those specified in the technical specification.If the
generator is stored in an area where the environmental conditions fall outside of those specified, it is essential that it be moved to its final
location (installation site) and left to stabilise prior to unpacking. Failure to do this could cause condensing humidity and potential failure of the
generator.

2.3.2 Unpacking

Once ready to install, remove the equipment from the packaging and check for signs of damage. Verify that the following items have been
included with the shipment:
Ref Description
1 Nitrogen generator
2 Mist-x spares kit
3
UK electrical supply cable
4
European electrical supply cable
5
US electrical supply cable
6 1/8" BSP male x 1/4" O/D adaptor
1. Supplied with 230 Vac generators
2. Supplied with 120 Vac generator
If any items are missing or damaged please contact your local Parker Hannifin office. Do not attempt to power up the generator.

2.3.3 Overview of the equipment

Key:
1 Control panel
2 Inlet air pressure gauge
3 N2 receiver pressure gauge
4 N2 outlet pressure gauge
5 Air receiver pressure gauge
6 Air outlet pressure gauge
7 Drain port
Qty
1
1
1
1
1
1
2
1
2
6
13
8 Fused IEC320 inlet socket
9 ON/OFF switch
10 N2 outlet port
11 N2 outlet port (MFC)
12 Dry Air outlet port
13 Air inlet port (Option 0)
14 Compressor box (Option 1)
12
11
14
10
9
8
7
5