Stryker Altrix 8001 Mode D'emploi page 51

21. Pull up on the controller drain plug (Figure 36) to open the drain.
A
F F i i g g u u r r e e 3 3 6 6 – – D D r r a a i i n n p p l l u u g g
22. Make sure that all 3 hoses remain raised above the connection ports for draining.
23. Allow the controller and hoses to drain for a minimum of two minutes.
24. Push down on the controller drain plug to close the drain.
25. Empty the water from the drain pan, if applicable.
26. When the controller and hoses are drained, continue to Rinsing the internal water circuit and hoses (page 47).
R R i i n n s s i i n n g g t t h h e e i i n n t t e e r r n n a a l l w w a a t t e e r r c c i i r r c c u u i i t t a a n n d d h h o o s s e e s s
C C A A U U T T I I O O N N - - Always use sterile distilled water or distilled water that has been passed through a filter less than or equal to
0.22 microns with this product.
1. Using appropriate measuring equipment, fill the empty reservoir with one gallon (3.8 L) of sterile distilled water.
2. Place the reservoir into the controller.
3. Connect the bottom hose end to the hydraulic connector in the lid of the reservoir.
F F i i g g u u r r e e 3 3 7 7 – – B B o o t t t t o o m m h h o o s s e e e e n n d d i i n n t t h h e e l l i i d d o o f f t t h h e e r r e e s s e e r r v v o o i i r r
4. Plug the power cord into a wall outlet.
5. Press and hold the Stand-by button.
6. Tap the Manual mode icon.
8001-109-005 Rev AA.3 47 EN