D D i i s s i i n n f f e e c c t t t t h h e e i i n n t t e e r r n n a a l l w w a a t t e e r r c c i i r r c c u u i i t t a a n n d d h h o o s s e e s s e e v v e e r r y y 1 1 4 4 d d a a y y s s

Use the K K l l o o r r k k l l e e e e n n M M e e d d i i c c a a l l disinfectant tablets manufactured by M M e e d d e e n n t t e e c c h h or equivalent, before first use, at least every

14 days, and before storage. K K l l o o r r k k l l e e e e n n M M e e d d i i c c a a l l disinfectant tablets have been validated for internal water circuit

disinfection. Make sure that you follow the disinfectant manufacturer's guidelines to avoid the risk of injury. Failure to follow

the disinfectant's instructions may void your warranty.

C C A A U U T T I I O O N N

• Always use sterile distilled water or distilled water that has been passed through a filter less than or equal to 0.22

microns with this product.

• Do not disinfect the internal water system with a thermal transfer device attached as this may cause a leak.

• Do not use bleach or any other cleaning or disinfectant agents for internal circuits. This could result in damage to the

product. Only use approved disinfectant tablets.

• Always drain the product before disinfecting the internal water circuit. Failure to drain the product may reduce the

effectiveness of the disinfection process.

N N o o t t e e - - Disinfection of the A A l l t t r r i i x x internal water system was validated using M. mucogenicum .

T T o o o o l l s s R R e e q q u u i i r r e e d d : :

•

2 gallons (7.6 L) of sterile distilled water or distilled water that has been passed through a filter less than or equal to 0.22

microns

•

Personal protection equipment (PPE) as recommended by the disinfectant manufacturer's instructions

•

Soft, lint free cloth (2 or more)

•

2 K K l l o o r r k k l l e e e e n n M M e e d d i i c c a a l l tablets (active ingredient is sodium dichloroisocynaturate (NaDCC); 1874 ppm disinfectant

solution when dissolved in one gallon of water) or equivalent

•

Service tool adapter hose (8001-999-017) for C C o o l l d d e e r r style connector hoses

•

Floor drain or drain pan (800109990233)

See Product illustration (page 9) for clarification of product component names and locations.

D D r r a a i i n n i i n n g g t t h h e e i i n n t t e e r r n n a a l l w w a a t t e e r r c c i i r r c c u u i i t t a a n n d d h h o o s s e e s s f f o o r r d d i i s s i i n n f f e e c c t t i i o o n n

1. Unplug the power cord from the wall outlet.

2. Place the controller over a floor drain or drain pan.

N N o o t t e e - - For best results, the floor drain should be within reach of a wall outlet to power on the controller.

3. To drain the controller, pull up on the controller drain plug (A) to open the drain (Figure 29). Leave the drain open.

8001-109-005 Rev AA.3