PRO-POINT 8784720 Mode D'emploi page 20

8784720
REPLACING THE TIPS
1. Remove the used tips and recycle or dispose of them.
2. Coat the threads of the electrode tips with a heat sink
compound (sold separately).
3. Screw the tips into the upper and lower tong. Tighten to
secure, but be careful not to overtighten.
REPLACING THE TONGS
Follow Assembly & Installation step 3 to loosen and remove
the tong holders. Insert new tongs and follow the alignment
instructions in step 3.
CLEANING
Periodically clean dust, dirt, grease, etc. from your welding unit.
MAINTENANCE SCHEDULE
CAUTION! Disconnect the machine from the main power
supply before servicing or maintaining the machine.
Every three months:
1. Oil the unit's contact points where metal rubs against
metal, such as the operating lever.
2. Inspect the electrode tips for splaying or slag.
3. Replace damaged or unreadable labels.
IMPORTANT! Perform the maintenance procedures monthly
with heavy tool use.
STORAGE
When not in use for an extended period, apply a thin coat of
lubricant to the steel parts to avoid rust. Remove the lubricant
before using the tool again.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or
by-laws for electronic devices, batteries, oil or other toxic liquids.
20
220V SPOT WELDER
For technical questions call 1-800-665-8685
V1.0