PRO-POINT 8784720 Mode D'emploi page 13

V1.0
4. Prevent damage to the power cord by observing the
following:
4.1 Do not pull on the cord to disconnect the plug from
an outlet.
4.2 Keep the cord away from heat, oil, sharp edges or
moving parts.
4.3 Never use the cord to carry the tool.
4.4 Place the electrical cord in a position that prevents it
from coming into contact with the tool and getting
caught by the workpiece. The cord should always stay
behind the tool.
5. Do not allow people, mobile equipment or vehicles to pass
over unprotected power cords.
5.1 Position power cords away from traffic areas.
5.2 Place cords in reinforced conduits or place planks on
either side of the power cord to create a protective
trench.
6. Do not wrap the cord around the tool, as sharp edges may
cut insulation or cause cracks if wound too tight. Gently
coil cord and either hang on a hook or fasten with a device
to keep cord together during storage.
UNPACKING
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do so
could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and
inspect for damage. Make sure that all items in the contents are
included.
Contents: •
•
Visit www.princessauto.com for more information
220V SPOT WELDER
Spot Welder
Wooden Handle Assembly and Hardware
• Copper Electrode Tips, 2 pcs
8784720
13