Creating A Weld - PRO-POINT 8784720 Mode D'emploi

V1.0
6. The width between the tongs can also be adjusted with the
cap screw (J). The cap screw physically stops the operating
lever from lowering past a certain point.
The adjustments only apply within the gap range set in step 3.
6.1 Loosen the nut on the cap screw by several turns. This
screw locks the cap screw in place.
6.2 Tighten the cap screw to narrow the tong gap. Loosen
the screw to increase the tong gap.
6.3 Once set, adjust the nut on the screw to lock the cap
screw in place.

CREATING A WELD

1. Clean all weld areas on both workpieces to remove grease
or oil.
1.1 Use a file or scraper to remove paint, rust or metal scale.
2. Set the tong pressure.
3. Plug the tool into a power supply.
4. Insert the metal parts between the electrode tips and press
down on the operating lever (I) to bring the tips to welding
pressure. This will press the metal pieces together. The
tongs may deflect by a small amount.
CAUTION! Wear thick heat resistant gloves with small pieces
to avoid a burn injury, as the process will heat the metal.
5. Press the power switch (L) left or right to pass a current
through the workpieces. Release the switch and it will
automatically center itself in the OFF position.
6. Hold the tongs in place for a moment before raising the
operating lever to open the jaws.
7. Remove or reposition the workpiece.
8. Wait until the duty cycle completes before starting the next
weld (see Specifications).
Visit www.princessauto.com for more information
220V SPOT WELDER 8784720
17