PRO-POINT 8784720 Mode D'emploi page 11

V1.0
4. Do not alter any parts of the tool or accessories. All parts
and accessories are designed with built-in safety features
that may be compromised if altered.
5. Make certain the power source conforms to requirements
of your equipment (see Specifications).
6. When wiring an electrically driven device, follow all
electrical and safety codes, as well as the most recent
Canadian Electrical Code (CE) and Canadian Centre for
Occupational Health and Safety (CCOHS).
7. This tool is only for use on 240V (single phase) with a
three-prong grounded power supply cord and plug. Check
with a qualified electrician if you are in doubt as to
whether the outlet is properly grounded. If the tool should
electronically malfunction or break down, grounding
provides a low resistance path to carry electricity away
from the user.
7.1 Never remove the grounding prong or modify the plug
in any way, as this will render the tool unsafe.
7.2 Do not use any adapter plugs.
WARNING! All wiring should be performed by a qualified
electrician.
ELECTRIC TOOL PRECAUTIONS
1. Do not use any power tool with a malfunctioning power
switch or control. A power tool that fails to respond to the
controls is dangerous and can cause an injury. A qualified
technician must repair and verify the power tool is
operating correctly, before it can be used.
2. This equipment requires a dedicated 240 volt, 20 amp
single-phase alternating current circuit equipped with a
similarly rated circuit breaker or a slow blow fuse. Do not
run other appliances, lights, tools or equipment on the
circuit while operating this tool.
Visit www.princessauto.com for more information
220V SPOT WELDER 8784720
11