PRO-POINT 8784720 Mode D'emploi page 7

V1.0
1. Use the correct tool for the job. This tool was designed for
a specific function. Do not modify or alter this tool or use it
for an unintended purpose.
2. Do not weld if you are in an awkward position. Always have
a secure stance while welding to prevent accidents.
3. Keep all panels and covers securely in place when operating
the welding unit.
4. Do not exceed the equipment's rated capacity.
5. Use only correct fuses or circuit breakers. Do not oversize
or bypass them.
6. Turn off all equipment when not in use.
7. Overuse can cause overheating. Allow a cooling period;
follow the rated duty cycle.
8. Do not allow persons who are not familiar with the tool or
have not read these instructions to use the tool.
FIRE AND EXPLOSION PRECAUTIONS
Spot welding can produce sparks and hot spatter that can
start fires.
1. Clear the floor and walls of an area of all combustible
and/or flammable materials. Solid floors of concrete or
masonry is the preferred working surface.
1.1 Cover any combustible material with fire resistant
covers or shields, if it cannot be removed. The covering
must be tight and should not leave openings for sparks
to enter.
1.2 A combustible floor should be protected with a fire
resistant covering. Alternatives are to spray the floor
with water to keep it wet for the duration of the
welding or cover with damp sand. Care must also be
taken to avoid an electric shock when this is done. A
combustible floor directly laid onto concrete does not
need to be sprayed with water.
Visit www.princessauto.com for more information
220V SPOT WELDER 8784720
7