PRO-POINT 8784720 Mode D'emploi page 19

V1.0
3. Only use accessories intended for use with this tool.
4. Follow instructions for lubricating and changing accessories.
5. Keep the tool handles clean, dry and free from oil/grease at
all times.
6. Maintain the tool's labels and name plates. These carry
important information. If unreadable or missing, contact
Princess Auto Ltd. for replacements.
7. Make sure the electrode tips are clean. Dress the tips to
remove accumulated slag if necessary.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
DRESSING THE TIPS
Deformed electrode tips are a by-product of use. The tips
must be dressed to maintain the weld efficiency. Use a file or
a dresser tool to reshape the electrode tips.
1. Remove each electrode tip from the tool and either place it
in a vice or locking pliers. Only apply enough pressure on
the flat sides to hold the tip in place. Too much pressure
will deform the tip.
2. Remove the excess metal with the file or dresser tool.
Attempt to reproduce the original slope on all side.
3. Once the side are shaped, file
the point to a smooth surface
that is 1/8 in. in diameter (d).
You may choose to create a
narrower diameter point for
use with thinner workpieces.
4. Repeat steps 2 and 3 until the
tip is properly dressed.
5. Replace the tip if the dressing fails or the slope is too shallow.
Visit www.princessauto.com for more information
220V SPOT WELDER 8784720
Fig. 2
19