Pre-Filter Of The Pump Cleaning; Maintenance In Periods Of Non-Use Or Absence - Iberspa SM-COM-PR Manuel D'utilisation

ATTENTION
While the filter is being washed, dirty water is emptied through the drain
reducing the water level of the Spa. Once washing has been completed, check
the level and fill the Spa if necessary. The Spa will not work properly if there is
insufficient water, and may even cause a breakdown.
During the filter washing process, messages may appear on the control panel
display, such as HL or LF. These do not affect the operation as long as washing
and rinsing times are not exceeded, The equipment will become seriously
damaged if washing lasts longer than the set time.

7.3. Pre-filter of the pump cleaning

It is recommended to periodically check the condition of the pre-filter of the pump to
avoid it from blocking. If debris has accumulated, the pre-filter should be opened and
cleaned.
Follow these steps to clean the pre-filter:
1. Turn off the Filtering Pump by placing the selector in the OFF position.
2. Close the valve of the filtering circuit that connects the pump to the Spa.
3. Using the key supplied with the equipment, turn the upper cover of the pre-filter
anticlockwise until
it becomes loose. Remove the basket of the pre-filter to clean it.
4. Put the basket back into place. Place the joint of the cover to close it using the key.
5. Open the filtering circuit valve.

7.4. Maintenance in periods of non-use or absence

Read the following advices to take care of your spa when you are not using it or you are
absent.
SHORT PERIODS (3-5 days)
• Adjust the pH and treat the water (see Water Maintenance section)
• Cover the spa.
• Before using the Spa again, readjust the pH and treat the water again.
PROLONGED PERIODS (5-14 days)
• Set the temperature at its lowest level.
ENG
31