Iberspa SM-COM-PR Manuel D'utilisation page 10

FILTERING CIRCUIT
Connect the suction circuit of the filtering pump to the outlet of the Spa Skimmer, placing
two ball valves to stop the water flow if necessary.
Connect the filtering return, the heater outlet, to the impulse inlet of the Spa, placing two
ball valves to stop the water flow if necessary.
Make a by-pass in the filtering return circuit to the drain, to enable you to empty this circuit
in the event of a breakdown of the heater. It will also be used to empty the spa.
AIR
JETS 1
INJECTORS
CHECK
VALVE
BLOWER
PUMP
MANOMETER
It is not necessary to use teflon tape, as a joint seals this point. Do not use a tool to tighten
the T-part of the pressure gauge, simply tighten it with your hands.
10
DRAIN 1 JETS 2
MASSAGE
PUMP 1
DRAIN 2 SKIMMER
MASSAGE
PUMP 2
BOTTOM
DRAIN 3 IMPULSE
CLEANER
FILETRING
PUMP
FILTER
SELECTOR
VALVE
DRAIN
045
044