Pre-Set Filter Cycles - Iberspa SM-COM-PR Manuel D'utilisation

Main Screen Main Screen
J

PRE-SET FILTER CYCLES

Main Screen
to show RUN HRS
to show F1 ENDS xx:xx
To next item in
Main Menu
to show RUN HRS
to show F1 ENDS xx:xx
PURGE CYCLES | TP600
In order to maintain sanitary conditions, as well as protect against freezing, secondary
water devices will purge water from their respective plumbing by running briefly at
the beginning of each filter cycle. (Some systems will run a certain number of purge
cycles per day, independent of the number of filter cycles per day. In this case, the
purge cycles may not coincide with the start of the filter cycle.)
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter Cycle 2 will initiate a
purge when Filter Cycle 2 is programmed to begin.
MEANING OF FILTER CYCLES
1. The heating pump always runs during the filter cycle*
2. In Rest Mode, heating only occurs during the filter cycle
| TP600
While the Temperature is still
flashing, press Light repeatedly
until MODE appears in the LCD.
Shows/flashes start time Sets start hour
Sets Filter 1 length in hours
To Set
To Set
Waiting
Several Seconds
Reverts to Original Setting
*****
Sets start hour
Shows/flashes start time
Sets Filter 1 length in hours
| TP600
Selects minutes
Sets 15-minute increments
Sets 15-minute increments
Selects part of an hour
To Set
*****
Waiting several seconds will lose
any new Filter 1
Start Time and Run Hours and revert
to the previous Filter 1 settings.
Main Screen
To Set
Selects minutes Sets 15-minute increments
Selects part of an hour
Sets 15-minute increments
Main Screen
To Set
*****
Waiting several seconds will lose any
new Filter 2 On/OFF,
Start Time and Run Hours and revert
to any previous Filter 2 settings.
ENG
Waiting
Several Seconds
Reverts to Original
Setting
*****
Wait to Revert
*****
Waiting
Several Seconds
Reverts to Original
Setting
*****
*****
Main Sc r een
23