Maintenance In Periods Of Non-Use Or Absence; Water Maintenance - Iberspa 43639 Manuel D'utilisation

Masquer les pouces Voir aussi pour 43639:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 66
Once a week, clean the area of the Spa which is not underwater with a quality polish for
Spas.
ATTENTION
Remember to never leave the Spa uncovered, empty and exposed to the sun,
as it could cause damages that the warranty does not cover.

6.3. Maintenance in periods of non-use or absence

SHORT PERIODS (3-5 days)
• Adjust the pH and treat the water (see Water Maintenance section).
• Cover the spa.
• Before using the Spa again, readjust the pH and treat the water again.
PROLONGED PERIODS (5-14 days)
• Set the temperature at its lowest level.
• Adjust the pH and treat the water (see Water Maintenance section).
• Cover the Spa.
• Before using the Spa again, reset the temperature as required , readjust the pH and treat
the water again.
PREPARTING FOR THE WINTER PERIOD
If it is not planned to use the Spa through the winter season or for prolonged periods of
time, the following operations should be done:
• Disconnect the electrical equipment.
• Empty the water from the Spa.
• Leave the drain valve open.
• Clean and dry the Spa.
• Cover the Spa.
You should not leave water in the Spa without an electrical connection outdoors in
temperatures below 0ºC, given that the pipes could freeze and damage the Spa.
It is necessary to comply withRegulations in force in each country regarding Legionella.
All responsibility for compliance with these falls on the owner of the Spa.

6.4. Water maintenance

30

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

16412ce04015ce05135ce

Table des Matières