Swisscom Office 30 Mode D'emploi page 129

Assigning the various key types
Each line key is provided with a light emitting diode (LED) and an identification label, with
the LED indicating the status of the line.
Line key setting
¥ ß
Other settings are available by pressing the MENU key: Under the menu point "Allocate",
you can select whether the line will be allocated by either lifting the handset, pressing the
Loudspeaker key or by pressing the Line key. In the same way you can select whether and
how a call will be answered on a line, under "Answer".
Note Line keys can also be set in the programming mode under "Line setting".
Making and receiving calls over lines
If you lift the handset or press the Loudspeaker key, your telephone automatically
allocates a line, which is then displayed in the lower right of the display. By pressing
another line key, you will change the line.
The line will also be indicated for incoming calls. If several calls arrive at the same time on
different lines, the call corresponding to the highest engaged Line key will be displayed.
Switching between lines
You can switch between calls on lines by pressing the Line key. The active line is
automatically parked. This allows you to answer calls on other lines or take up parked
connections again. You cannot, however, take up conversations on engaged lines.
20261949en_ba_h0
All manuals and user guides at all-guides.com
LED unlit: line is free
LED is permanently lit : line is busy
LED blinks fast: incoming call being received on
this line
LED blinks slow: line is parked or on hold
Press Line key until the menu "Line seizure"
appears. Select the desired adjustment under
"Ring": off, on, after 10 s. Confirm with "Ok".
Ok
In this way you can determine whether and how
an incoming call is to be indicated acoustically.
21