Operation
Switching the Unit On
EN
The extractor is switched ON and OFF at the On / Off switch (9).
When the unit is switched on:
♦ All 4 displays light up (the display carries out a functional control).
♦ The suction unit performs an automatic filter cleaning sequence
(for approx. 8 seconds, loud vibrating noise).
Select Mode: CAM-mode / continuous operation
• CAM-mode (20):
♦ The extraction unit is controlled by the signals provided by the CAM device.
• Continuous operation (22):
♦ The extraction unit runs continuously.
⇒ Press the operating mode key (21).
♦ To change the operating mode.
The extraction unit is for use with dry dust only!
When connected to a CAM device with wet and dry function, ensure that no residual moisture
from the CAM device enters the extraction unit.
Check that the extraction unit is in full working order for every milling procedure:
► Display error (26) is off.
► Suction turbine operates correctly without producing any peculiar noise or odor.
Cleaning / Maintenance
Opening the device, other than for the processes described below, is not permissible!
Cleaning
Use a damp cloth to clean the outside of the unit (factory settings 50 h). Do not use abrasive or sol-
vent-based cleaning agents.
Empty Dust Drawer
After the set time period has expired a signal to empty the dust drawer will occur (factory settings 50 h).
Before the dust drawer is emptied, a filter cleaning function is carried out so that loose dust particles fall
into the dust drawer.
The time period has expired:
♦ An acoustic signal will occur 3 times.
♦ The display dust drawer (24) lights up.
When the suction has stopped, an acoustic signal occurs 3 times and a filter cleaning function is carried
out.
When the filter cleaning function has finished:
⇒ Pull the dust drawer (3) out to the front and empty.
⇒ Replace the dust drawer until it clicks into place.
⇒ Press the enter key (25) (the counter which determines the time period is re-set).
♦ An acoustic signal confirms the input.
♦ The display dust drawer (24) light disappears.
If the dust drawer is not emptied, the display for the dust drawer will remain alight (24). When the
unit is switched off/on an acoustic signal will occur to remind that the dust drawer needs empty-
ing.
For information on setting the required time period see the quick reference card which is supplied or go to
the instructions for use in the Internet.
- 4 -