Step 3 - Turn On Your Monitor; Channel Selection - Angelcare AC423-D Manuel De L'utilisateur

STEP 3 - TURN ON YOUR MONITOR

1
If there is a lost connection
between the 2 units
(refer to troubleshooting p. 56):
• The Out-of-range icon
(if activated) will blink
on the screen and the Parent
Unit will beep.

CHANNEL SELECTION

1
2
3
4
52
All manuals and user guides at all-guides.com
2
1) Press the Parent Unit ON/OFF button
2) Slide ON the Nursery Unit Power
TO SELECT THE CHANNEL:
1) Press the Channel button
2) Press and hold the Nusery Unit back
3) Press and release the Nusery Unit back
4) Press and hold the Nusery Unit back
Der Schutzengel im Kinderzimmer
AC423-D
for 2 seconds.
ON/OFF button.
NOTE:
The screen of the Parent Unit will show
the channel of transmission (C1 to C8).
Then temperature reading will replace
the channel display.
If there is no temperature display, turn OFF
and then ON the Nusery Unit again. The
channel display will then turn to temperature
reading
in one minute.
to enter the channel mode.
The Antenna icon
will blink.
button until the Night Light flashes.
The Antenna icon
will blink with present
of the channel
number display
button to change the channel your
monitor transmits on (C1 to C8).
button until the Night Light stops
flashing to confirm your channel
selection and quit to normal mode.
NOTE :
If the transmission is not clear, or if you hear
interference sounds, you should change
the channel.
®