Step 3 - Turning On Your Monitor; Channel Selection - Angelcare AC420 Manuel De L'utilisateur

STEP 3 - TURNING ON YOUR MONITOR

1

CHANNEL SELECTION

1
2
When the Parent Unit is turned ON
and the Nursery Unit is OFF
OR
If there is a lost connection
between the 2 units (refer to
troubleshooting):
The Out-of-Range icon will blink
on the screen and the Parent Unit
will beep.
2 3 4
1) Press the Parent Unit ON/OFF button
for 2 seconds.
2) Slide ON the Nursery Unit Power
ON/OFF button.
NOTE:
The screen of the Parent Unit will show the
channel of transmission (C1 to C8) and after
5 seconds the room temperature and
function icons.
TO SELECT THE CHANNEL:
1) Press the "CH" key to enter or exit
the Channel Selection mode. The "--"
symbol will appear along with the In
Range icon which will flash.
2) Press the channel selector on the
Nursery Unit until the Night Light halo
flashes.
3) Select the channel by gently pushing
the channel selector on the Nursery
Unit (you will see the channel changing
on the Parent Unit).
4) Once the channel is selected, press and
hold the Channel Selector button on
the Nursery Unit to confirm selection
(halo will stop flashing to confirm
selection).
NOTE :
Both units are always on the same channel.
If the transmission is not clear, or if you hear
interference sounds, you should change the
channel. If the interference persists, consult
the Troubleshooting section.
E
N
11