Asko HI1345G Mode D'emploi page 20

FAULTS
Symptom
A fuse blows as soon as the
hob is switched on.
Fault code F00.
Fault code F0 ... F6 and FC.
Fault code F7.
Fault code F8 and F08.
Fault code F9 and/or
continuous beep.
Fault code F99.
Fault code FA.
Fault code FAN.
Fault code E6
Other fault codes.
EN 22
Possible cause
The hob has been wrongly
connected.
The control panel is dirty or
has water lying on it.
Defective generator.
The ambient temperature is
not good.
Appliance over heated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
You have pressed two or more
buttons at the same time.
Mains voltage is too low.
Air circulation not good.
Wrong pan.
Hardware / software error.
Defective generator.
Solution
Check the electrical
connections.
Clean the control panel.
Contact the service
department.
Switch off all heat sources
in the vicinity of the cooking
plate.
The appliance has been
switched off because of over
heating. Let the appliance cool
down and start again on a
lower setting.
Let your connection be
changed.
Do not operate more than one
button at the same time.
Contact your energy supplier.
Make sure the venting holes
under the cooking plate are
open.
Suitable pans are available via
the website 'www.asko.com'.
Contact the service
department.
Contact the service
department.