Mounting The Motor - Reely SKY 1:9 Pilatus PC-6 Turbo Porter Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

n) Mounting the Motor
These operating instructions show installation of an
electrical motor for illustration.
Required accessories are not included with the kit and
must be purchased separately. For notes on recommended
motor sizes, see chapter „Technical Data" at the end of
these operating instructions.
The model is also suitable for a 2-stroke combustion
engine with a displacement of 6.5 - 7.5 ccm or a 4-stroke
combustion engine with a displacement of 7.5 - 10 ccm.
Installation of a combustion engine is not explained in
these operating instructions and must take place according
to your own discretion.
If a combustion engine is installed, we recommend thinly
sealing the entire motor compartment against ingressing
fuel and oil with 30-minute epoxy resin.
Install the motor at the motor carrier as shown in figure 11a.
To be able to later set the motor inclination and side pull, as well as the
distance between spinner rear plate and motor cowl precisely, we
recommend using washers as a support or using adjustable motor
holders or threaded rods (figure 11, item 1).
Use drive-in nuts on the rear for this (figure 11, item 2).
Since motor inclination and side pull depend on the performance range of the motor and the
rotor used, these instructions cannot provide any concrete note in the required settings.
The best values for your model must be found out by flying starting from a basic setting
(1.5° inclination, 2.5° side pull). Observe figure 11b.
Figure 11a show the holes pre-drilled ex works for the motor carrier of the
combustion engine (figure 11, item 3). Item 4 shows a possible installation site for
the speed controller.
36
Figure 11a
Figure 11b

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

51 79 86

Table des Matières