Fitting Instructions - bort medical 215 200 Mode D'emploi

– in case of persistent complaints, consult the physician or specialist
retailer
– use the medical device in accordance with therapeutic needs
– only use other products simultaneously after consultation with your
physician
– do not make any changes to the product
– do not wear it on open wounds
– do not use in case of intolerance of one of the materials used
– no re­use – this medical aid is intended for treating one patient
– whilst wearing the brace, please neither use any creams nor ointments
in the vicinity of the attached aid as they can destroy the material

Fitting instructions

1
Before putting it on, set the thumb wrap and the wrist fastener to the
largest possible circumferences and pull the BORT Generation wrist­
thumb brace over the thumb/metacarpus and lower arm.
2
Then, set first the thumb wrap and next the wrist cord strap to the
individual width using the Velcro surfaces.
3
Finally close the brace fully.
If required, the internal aluminium reinforcement splint can be removed
from the brace and be individually formed by an expert.
Removal
Open all the Velcro fasteners and pull the brace off over the fingers. Close
the Velcro fasteners in order to avoid early wear to the Velcro surface.
EN
09