Fitting Instructions - bort medical select TaloStabil Mode D'emploi

– do not use in case of intolerance of one of the materials used
– no re-use. This medical aid is intended for treating one patient only
– whilst wearing the support, please neither use any creams nor ointments on or
around it as they can destroy the material.

Fitting instructions

Slip your foot into the slip-on aid provided. Then, grasp the upper edge of the support
and pull it over the slip-on aid, then pull it up further until the tops of the ankles are
in the rounded pad recesses. Check the positioning of the support and correct it as
applicable. When ready, pull the slip-on aid out of the support at the front.
Removal
To remove the support, please grasp the lower edge and pull it down over the foot.
Material composition
Polyamide (PA), elastodiene/Latex (LA), elastane (EL).
The sewn in textile label provides the precise material composition.
The product contains latex and can trigger allergic reactions.
Cleaning information
Delicate wash 30 °C
Do not iron
Do not use fabric conditioner. Stretch back into shape and dry in the fresh air.
Guarantee
The legal regulations of the country in which you acquired the product apply to the
purchased product. Please contact your specialist retailer if you suspect a warranty
claim. Please clean the product before submitting a warranty claim. If the enclosed
instructions for use have not been properly observed, the warranty may be impaired
or cancelled. The warranty does not cover use of the product inappropriate for
Do not bleach
Do not clean chemically
Do not dry in a tumble dryer
EN
07