EN
+
Please observe the "important instructions" enclosed with the rechargeable battery.
+
When starting up the application device for the first time, it will not work if you try
using it without charging the battery [9] before. The battery [9] was set to the "storage
mode" automatically.
2. Check whether the device main switch [16] on the operating unit [8] is set to position
"OFF". Connect the cable of the battery [9] with the main cable of the device [17] which
can be found in the side pocket of the carrier unit [1] (Fig. 4).
+
Ensure that the connectors lock with an audible click.
+
Store the battery and cable in the side pocket of the carrier unit.
3. Connect either a 5-liter tank or a 1-liter bottle filled with TESSIOR
in place with the intended devices (Fig. 5).
4. Remove the original cap of the tank and screw on the tank cap [2] belonging to the dos-
ing system (Fig. 6).
+
Ensure that the suction hose is not bent and the filter is firmly seated in the housing.
Spraying
Observe the instructions in the section entitled "Safety".
Operate the device only while it is vertical or suspended upright and nearly vertical.
Avoid allowing drops of spray to drift onto areas that are not being treated.
Observe the instructions of the spray product manufacturer!
1. Set the device main switch [16] on the operating unit [8] from "OFF" to "ON". The oper-
ating unit display turns on and shows the currently selected setting (MODE) [18] and the
charge level (BAT) [19] of the battery (Fig. 7).
+
When the unit is switched on, it shows at first "MODE: ST". Now the device is still
locked (STOP) and the spray gun [4] without function.
+
The charge level of the battery is indicated by a bar. When 4 bars are shown, the
battery is fully charged. If 1 flashing bar is shown, the charge level is below 20 %. It
is also possible to query the charge level via the LED display on the battery [8] by
pressing the button. Please find more detailed explanations in the "important instruc-
tions" enclosed with the rechargeable battery.
2. Switch to "MODE: C" (CONTINUOUS) by pressing down the selector switch [20] on the
operating unit [8] once. Operate the switch [21] on the spray gun [4] until all the air is
removed from the system (Fig. 8).
+
Spray the plant protection product on grape wood. Do not allow it to get on the
ground or in water.
+
Never spray longer than 60 seconds in "Mode: C". Parts of the device
may overheat or get damaged!
3. Put the application device on your back and close the hip belt [22]. Set the hip belt [22]
to the correct length and adjust it on hip level. Adjust the length of the shoulder belts [23].
Close the chest strap [24] and also fit its length. Secure the cable/hose unit [5] with the aid
of the strap [6] on your arm if necessary (Fig. 9).
All manuals and user guides at all-guides.com
21
ENGLISH
with the unit and lock
®