Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RECORDING VOICE MESSAGE FROM PC
To create a COMMON voice message from the PC you have to:
1 .
Select the heading "Phones" from the drop-down menu of the
SWLINK software interface and then "Common messages",
2 .
Write the text of the common message in the "Voice Message"
column . The duration of the message depends on the number
of common messages you intend to write . You can write up to
8 messages of a duration of 12 seconds each;
3 .
Play the text to check how it sounds; some words may not
convert correctly and may have to be adjusted with accented
vowels (for example, if the play out of the word "resumé" is
wrong, it should be rewritten as "resume" without the accent .
If the playing time of the text written is longer than the limit
allowed (see table above), an error message is displayed, the text is
coloured red and it is not saved .
To create a voice message from a PC ASSOCIATED with an input,
area, output or scenario, you have to:
1 .
Select the heading "Inputs" from the drop-down menu of the
SWLINK software interface
2 .
Write the text of the common message in the "Voice Message"
column .
3 .
Play the text to check how it sounds; some words may not
convert correctly and may have to be adjusted with accented
vowels (for example, if the play out of the word "resumé" is
wrong, it should be rewritten as "resume" without the accent .
If the playing time of the text written is longer than 1 .5 sec-
onds, an error message is displayed, the text is coloured red and it
is not saved .
SENDING VOICE MESSAGES
To send the edited voice messages to the control unit:
1 .
The control unit must be totally off .
2 .
You must open the programming window to the control unit .
3 .
Highlight "Voice messages" .
4 .
Launch programming .
5 .
If the PROGRAM . FROM PC parameter is:
•
WITH CTL-U OFF, you can launch programming .
•
AFTER USER CODE, before launching programming you
need to enter the user code .
Creating User Codes
The factory-set User Code 001 is 123456 and is enabled . The other
User Codes, from 002 upwards, although they may be present and
enabled, must be activated by assigning a new code to them .
Activating a User Code
1 .
Go into the Technical Menu .
(
)/(
)
2 .
With
select
CHANGE USER CODE
▲
▼
3 .
Enter the
using the number keypad (the code must
NEW CODE
have at least 4 digits) and press
4 .
If the code already exists a
5 .
Repeat the password to
CONFIRM CODE
(the code must have at least 4 digits) and press to confirm .
CODE 002 [#]
CODE 002
*
MODIFY
USER CODE
*
NEW CODE
******
CONFIRM CODE
******
The main management features of the User Codes, that are as-
signed in the factory and can be modified by the Installer, are:
All
All
Arming + Disarm .
and press (*) .
(*)
to confirm .
message is shown .
CODE NOT ACCEPTED
using the number keypad
▼ ▲
002
▼ ▲
Enabled
Enabled
Publicité
Table des Matières
