Cabling Rs-485 Bus; Traditional Cabling (Entry-Exit); Cabling With Branching - CAME PXC48 Manuel Installateur

Cabling RS-485 bus

If the remote devices have been installed correctly, all the bus communication LEDs on each device should flash . If some of them
don't flash, it means that the device has not been installed and programmed correctly (check cabling, address and programming in the
control unit) .

TRADITIONAL CABLING (ENTRY-EXIT)

CABLING WITH BRANCHING

The branching consists of a cable with 3 pairs, 2 of which are twisted (each pair is made up of conductors A and B) .
Analysing the circuit made in this way, you can see that the structure of the RS-485 bus is still linear (entry-exit) .