Fitting Instructions - R&G CP0305 Instructions De Montage

push
Page | 4

FITTING INSTRUCTIONS

Near side (left side as you sit on bike)

Remove the belly pan.

Remove the left hand side fairing.
Off side (right side as you sit on bike)

Remove the right hand side fairing.
Near side (left side as you sit on bike)

Stick the self-adhesive neoprene foam pads (item 11) to the mounting faces of the left and right
hand mounting assemblies (items 7 and 14) as arrowed in pictures 1 and 2 (and cut to suit).

Undo and remove the engine mounting bolt arrowed in picture 3.

Fit the spanning bar (item 10) to the left hand side mounting assembly (item 7) using the M8 bolt
and washer (items 8 and 9) as shown in picture 4 do not fully tighten at this stage.

Offer this assembly through the space in front of engine as shown in picture 6. Please ensure the
spanning bar is clear of the radiator fan and the exhaust down pipes.

Use the shorter M12 cap headed bolt (item 12) to secure in position as shown in picture 5 (do not
fully tighten at this stage).
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 5
PICTURE 7
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email:
PICTURE 6
push
PICTURE 8
info@rg-racing.com