Dolmar TM-98.14 H2D Manuel D'utilisation page 117

HOW TO USE THE MACHINE
5.3 DIRECTIONS BEFORE STARTING THE WORK
Before starting work, it is necessary to carry out several checks and operations
to ensure that the work gives the best results and is done in maximum safety
5.3.1 S
EAT ADJUSTMENT
To change the seat position, loosen the
four fixing bolts (1) and slide it along the
bracket slots.
Once you have found the position, tighten
the four screws (1).
5.3.2 T
YRE PRESSURE
Having the correct tyre pressure is the main condition for ensuring that the cut-
ting deck is horizontal and thus mows evenly.
Unscrew the valve caps and connect a
compressed air line with a gauge to the
valves.
The pressures are:
FRONT
REAR
5.3.3 F
ILLING WITH OIL AND FUEL
NOTE
With the engine stopped, check its oil level: according to the exact methods
1.5 bar
1.2 bar
The type of oil and fuel to use is given in the engine manual.
1 1
EN 19