Dolmar TM-98.14 H2D Manuel D'utilisation page 108

EN 10
3.2 FITTING THE STEERING WHEEL
Put the machine on a flat surface and
straighten up the front wheels.
Fit the steering wheel (1) onto the protruding
shaft (2) with the spokes directed towards
the seat.
Line up the hole in the steering wheel hub
with the hole in the shaft and insert the pin
supplied (3) using a hammer, ensuring that
the end comes completely through to the
opposite side.
NOTE
screw-driver of the same size as the pin when hammering it in the last part.
3.3 FITTING THE SEAT
Fit the seat (1) onto the plate (2) using the
screws (3).
3.4 ASSEMBLY AND CONNECTING THE
BATTERY
Position the battery (1) in its compartment
under the seat.
Connect the two red cables (2) to the posi-
tive terminal (+) and the three black cables
(3) to the negative terminal (–) using the sup-
plied screws and following the illustrated
sequence.
Fit the spring (4) to hold the battery in place
and make sure all the wires are in front of the
battery so that they don't get caught in the
spring (4).
IMPORTANT
battery according to the instructions in the
battery booklet ( ☛ 6.2.5).
To avoid damaging the steering wheel, use a punch or a
Always fully charge the
UNPACKING AND ASSEMBLY
2
3 3
2
1 4
2 3 1
1
3