Dolmar TM-98.14 H2D Manuel D'utilisation page 140

EN 42
6.4.3 R
EPLACING BULBS
The bulbs (18W) have a bayonet fitting and are
installed in the bulb holder which can be taken out
by turning it anti-clockwise, using pliers.
6.4.4 R
EPLACING A FUSE
The machine is fitted with fuses (1) with different
capacities and functions. Specifically:
– 6.3 A (delayed) fuse (1) = protects the main and
power circuits of the electronic board. When it
blows, the machine stops and the dashboard
light switches off.
– 25 A fuse (2) = protects the battery charger cir-
cuit. When it blows, the battery gradually runs
out and the machine will have problems start-
ing.
The fuse capacity is indicated on the fuse.
IMPORTANT
type and ampere rating, and never with one of another rating.
If you cannot find out why the fuse has blown, consult a Licensed Service Cen-
tre.
6.4.5 R
EPLACING BELTS
Replacing belts is quite a complicated process of dismantling and subsequent
adjustment and must only be carried out by a Licensed Service Centre.
NOTE
wear! ALWAYS USE GENUINE REPLACEMENT BELTS!
➤
( if fitted)
A blown fuse must always be replaced by one of the same
Replace the belts as soon as they show obvious signs of
MAINTENANCE
1
2